Please Leave Us A Message
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
2018-12-07
Maintenance of the Manual Flush Valve is usual,but if you need the professional help from the handy Flush Valve factory ,here we will take a look at the repair method of the Manual flush valve.
handy is a professional flush valve manufacturer,supply flush valve to America,Africa,Southest Asia,Malyasia and so on.Good polished flush valve can take five years without leakage,if the manual flush valve flushing too long;or the valve stem larkage,can not loose; Flush valve block does not return, perennial draingage.Here you need take a look at these tips.
1.Before install the manual flush valve,it is essential that you thotoughly flush through the supply pipes in order to remove and remaining swarf,solder or other impurities.Failure to carry out this simple procedure could cause problems or damage to the working of the flush valve.
2.Working water pressure is 0.1-1.0Mpa,the water pressure is higher or lower influence the time life of the flush valve.
3.The flushing time of the flushing valve is too long and can be used to deepen the time delay filling the sink with scraper tools. Should be appropriate and line, otherwise, the short flushing time can not be remedied.
4.Valve leakage, do not close, check the body of the valve if there is debris, after checking that there is no debris to see whether the rubber ring wear and deformation, fastening pressure flange whether loose, according to the situation to change the seal water rubber ring, spin tight pressure flange.
5.Rinse the valve block does not return to normal running water. After confirming that there is no debris, check whether the rubber ring and pad have become soft and deformed. This kind of problem has been found. Generally, the rubber ring water absorption rate is too high to expand and the plug can not work normally in the valve body. Qualified rubber rings and pads should be replaced.
Handy manual flush valve is in five layer plated by chrome,nickel,copper,No.59 brass casting.Handy manual flush valve is self-closing time delay flush valve,time delay from 3-8 seconds.handy flush valve is in brightness after 48 hours salt spray testing.The inlet pipe is suitable for 1G" solenoid pipe.handy manual flush valve supply service hot line 400-0004168.
Share to:
Send Inquiry
Ms. lily
Tel:86-0755-82292166
Fax:86-0755-82185124
Mobile Phone:+8613751081118
Email:handy@vip.163.com
Address:FLATB,NO.1511,WENJINDU CUSTOMS BLDG.,DONGMEN, Shenzhen, Guangdong
Related Products List
Mobile Site
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.